|Clean Boiler Waterside Heat Transfer Surfaces|
|Written by USDOE Office of Industrial Technologies|
|Thursday, 01 July 2010 15:06|
Clean Boiler Waterside Heat Transfer Surfaces
Even on small boilers, the prevention of scale formation can produce substantial energy savings. Scale deposits occur when calcium, magnesium, and silica, commonly found in most water supplies, react to form a continuous layer of material on the waterside of the boiler heat exchange tubes.
Scale creates a problem because it typically possesses a thermal conductivity an order of magnitude less than the corresponding value for bare steel. Even thin layers of scale serve as an effective insulator and retard heat transfer. The result is overheating of boiler tube metal, tube failures, and loss of energy efficiency. Fuel waste due to boiler scale may be 2% for water-tube boilers and up to 5% in fire-tube boilers. Energy losses as a function of scale thickness and composition are given in the table below.
Note: “Normal” scale is usually encountered in low-pressure applications. The high iron and iron plus silica scale composition results from high-pressure service conditions.
*Extracted from National Institute of Standards and Technology, Handbook 115, Supplement 1. On well-designed natural gas-fired systems, an excess air level of 10% is attainable. An often stated rule of thumb is that boiler efficiency can be increased by 1% for each 15% reduction in excess air or 40°F reduction in the stack gas temperature.
Annual Operating Cost Increase = 450,000 MMBtu/yr x $8.00/MMBtu x 0.02
Monitor Flue Gas Temperature
Perform Visual Inspections
Adapted from an Energy TIPS fact sheet that was originally published by the Industrial Energy Extension Service of Georgia Tech.
FOR ADDITIONAL INFORMATION, PLEASE CONTACT:
EERE Information Center
Industrial Technologies Program
Energy Efficiency and Renewable Energy
U.S. Department of Energy
Washington, DC 20585-0121
|Development and Demonstration of a Biomass Boiler for Food Processing Applications
11/07/2011 | USDOE Energy Efficiency & Renewable Energy
Development and Demonstration of a Biomass Boiler for Food Processing Applications Pilot Demonstration of a Biomass Boiler that Utilizes a Combination of Wood Waste and Tire-Derived Fuel Introductio [ ... ]
|Saving Energy on Conveyor Belts|
09/06/2010 | Western Area Power Administration
(original article available here) Technical help Case example July 2003 Question: What can be done to save energy on conveyor belt systems? One of our utility's customers operates outdoor conveyo [ ... ]